richie00boy
Member
- Messages
- 1,023
I've got a Sip direct drive 3hp 50L compressor about 2005 vintage. The air intake plastic filter housings clip together and have had it. I want to replace them with something a little bigger, but am struggling to match the thread.
I've tried an M16 male fitting and it wouldn't even screw in. Then I tried a 3/8 BSP male fitting and it will engage a couple of threads, but it doesn't feel right.
I measured the thread outside diameter on the plastic filter housing at 15.7mm any ideas?
I've tried an M16 male fitting and it wouldn't even screw in. Then I tried a 3/8 BSP male fitting and it will engage a couple of threads, but it doesn't feel right.
I measured the thread outside diameter on the plastic filter housing at 15.7mm any ideas?