ronan
Member
- Messages
- 11,399
During the lockdown i decided to do something about the knackered bearings in the headstock of the Master 2500 i have. It became obvious that someone had been messing around in there previously, and didn't know what they were at.
There were thrust washers and circlips missing on the clutch shaft and other shafts.
Would anyone happen to have a picture of a colchester clutch shaft assembly, with matrix clutches disassembled ? I need to know the approximate thickness of two spacers, one that sits between the forward and reverse clutches, and another that sits at the right hand end of the shaft, held on by a (missing) circlip.
There were thrust washers and circlips missing on the clutch shaft and other shafts.
Would anyone happen to have a picture of a colchester clutch shaft assembly, with matrix clutches disassembled ? I need to know the approximate thickness of two spacers, one that sits between the forward and reverse clutches, and another that sits at the right hand end of the shaft, held on by a (missing) circlip.