James Brewer
New Member
- Messages
- 5
- Location
- Colchester uk
I have a hydrovane three phase compressor with a 500l freestanding tank 22cfm I believe so air is not going to be a problem.
Already have a manual plasma so I get the limitations of the thicknesses, will probably go for 100plus amp one and be done with it then keep my hand held odd jobs.
I would be up for having a crack at making one I get the impression that making the table etc is the easy part the problem is time it takeS to get it all to work well with software.
I realise that an 8x4 20mm Sheet is a hefty lump but unlikely to be cutting full sheets of it day in day out.
I wouldn’t mind having to beef up the framework on a cheaper machine if all the other components were of a good quality and up to the job as after all the framework of it is the most basic part.
I haven’t actually said how much I want to spend, don’t have a budget as such, I don’t want a cheap machine but one that represents good value for money.
Already have a manual plasma so I get the limitations of the thicknesses, will probably go for 100plus amp one and be done with it then keep my hand held odd jobs.
I would be up for having a crack at making one I get the impression that making the table etc is the easy part the problem is time it takeS to get it all to work well with software.
I realise that an 8x4 20mm Sheet is a hefty lump but unlikely to be cutting full sheets of it day in day out.
I wouldn’t mind having to beef up the framework on a cheaper machine if all the other components were of a good quality and up to the job as after all the framework of it is the most basic part.
I haven’t actually said how much I want to spend, don’t have a budget as such, I don’t want a cheap machine but one that represents good value for money.