Ok, Ive built a exhaust for my bike, but I couldnt get the purge baffle setup into two of the odd welds in the middle of the collector as its a very odd shape, and I have some scag inside there I want to clean up mostly to stop it flaking and getting blown into a very fast spinning turbine impeller and causing damage.
Whats the best tool for the job? I was thinking a flexi shaft with a flap wheel on the end of it fed in? Is there something as good as the external clean and strip discs for the job?
Diameter is 48mm and material is stainless 316 with 308 filler.
The patient in question...
I'm going to make a cabinet and purge it for stuff like this one day, when I win the lottery and can afford the gas to fill it
Whats the best tool for the job? I was thinking a flexi shaft with a flap wheel on the end of it fed in? Is there something as good as the external clean and strip discs for the job?
Diameter is 48mm and material is stainless 316 with 308 filler.
The patient in question...
I'm going to make a cabinet and purge it for stuff like this one day, when I win the lottery and can afford the gas to fill it