Hi all
Been stripping the rear of the mini and got the rear subframe apart. It is quite corroded but after a little tap with the hammer and a hole appeared... After a quick clean with a wire brush this is the result
The hole is at the bottom on passenger side at the heel board end.
My question is can i weld a patch over this or is it too far gone?
Cheers guys
David
Been stripping the rear of the mini and got the rear subframe apart. It is quite corroded but after a little tap with the hammer and a hole appeared... After a quick clean with a wire brush this is the result
The hole is at the bottom on passenger side at the heel board end.
My question is can i weld a patch over this or is it too far gone?
Cheers guys
David