Hi,
This is my first post on the forum.
I've got a Clarke PRO 90 which I've used to restore my 1983 mini!
It's been a fantastic welder, but today it hasn't been producing enough power to make welds penetrate.
On low the wire just glows and on full, there is no penetration.
I've has a multimeter on it and on full it's producing 25amps.
I've continuity tested and everything seems fine!
Any suggestions?
This is my first post on the forum.
I've got a Clarke PRO 90 which I've used to restore my 1983 mini!
It's been a fantastic welder, but today it hasn't been producing enough power to make welds penetrate.
On low the wire just glows and on full, there is no penetration.
I've has a multimeter on it and on full it's producing 25amps.
I've continuity tested and everything seems fine!
Any suggestions?