Hi,
I am new to mig welding and have a Clarke MIG 135TE. For safety's sake I try to weld outside the front of my small garage but the wind effects the weld by disturbing the shielding gas. Is it possible to change the polarity on the welder, use a 0.9mm drive roller, change the feed tube and use 0.9mm flux core wire to overcome this wind problem? Would welcome any constructive advice.
I am new to mig welding and have a Clarke MIG 135TE. For safety's sake I try to weld outside the front of my small garage but the wind effects the weld by disturbing the shielding gas. Is it possible to change the polarity on the welder, use a 0.9mm drive roller, change the feed tube and use 0.9mm flux core wire to overcome this wind problem? Would welcome any constructive advice.