Jbo2231
Member
- Messages
- 170
- Location
- essex - UK
Hoping someone out there can offer advice/assistance.
I recently acquired the above machine second hand. Unfortunately I was stitched up, perhaps unintentionally and i cant really complain for the 50quid it cost and it's basically brand new.
The disc does not run true and has a few mm of runout, appears it is common issue with them!
This is a review I found on Amazon post purchase .
Any way to get this flat? Unfortunately dont have a lathe and havent taken it apart yet so not sure if its removable/adjustable but any ideas/experience? Plate seems a good 1cm thick so hopefully can machine it down a bit.
Reason I wanted it was to get perfect fitment on mitre joints/lengths and a wobbly disc ruins that unfortunately.
I recently acquired the above machine second hand. Unfortunately I was stitched up, perhaps unintentionally and i cant really complain for the 50quid it cost and it's basically brand new.
The disc does not run true and has a few mm of runout, appears it is common issue with them!
This is a review I found on Amazon post purchase .
Any way to get this flat? Unfortunately dont have a lathe and havent taken it apart yet so not sure if its removable/adjustable but any ideas/experience? Plate seems a good 1cm thick so hopefully can machine it down a bit.
Reason I wanted it was to get perfect fitment on mitre joints/lengths and a wobbly disc ruins that unfortunately.