Hi,
I have a Clarke 151en which has had very little use. I struggled for a day with the wire feed, it was very jumpy then on the next day wouldn't feed at all. I've tested the DC motor and that works fine but when I press the trigger no power is going to the motor. The relay on the PCB clicks but nothing. I was assuming it was the PCB which looks fairly simple compared to some I've seen but I don't really know what to check past basics like resistors diodes etc. I swapped the TYN608 but no luck. Any ideas?
Thanks
I have a Clarke 151en which has had very little use. I struggled for a day with the wire feed, it was very jumpy then on the next day wouldn't feed at all. I've tested the DC motor and that works fine but when I press the trigger no power is going to the motor. The relay on the PCB clicks but nothing. I was assuming it was the PCB which looks fairly simple compared to some I've seen but I don't really know what to check past basics like resistors diodes etc. I swapped the TYN608 but no luck. Any ideas?
Thanks