Hi,
I seem to be having some hassles with the wire speed setting on my Cigweld Transmig 200...
It will adjust slightly, but the range of adjustment seems to have reduced substantially - I can't get it to slow down to anything below about 6 - 8 meters/minute (at a guess).
Any ideas what this could be, is it just the pot? Is this a known issue with MIG's?
Thanks,
Jonty
I seem to be having some hassles with the wire speed setting on my Cigweld Transmig 200...
It will adjust slightly, but the range of adjustment seems to have reduced substantially - I can't get it to slow down to anything below about 6 - 8 meters/minute (at a guess).
Any ideas what this could be, is it just the pot? Is this a known issue with MIG's?
Thanks,
Jonty