Centrifugal clutch.

[God mode restorations]

Evening guys.
Do any of you guys have a large boar suco style centrifugal clutch hiding in your shed/workshops.

 

[God mode restorations]

What sort of bore (I'm assuming you mean hole in the middle rather than wild pig ) size do you need?

What sort of bore (I'm assuming you mean hole in the middle rather than wild pig ) size do you need?

I have slightly different sized shafts... I have one shaft at 37.5mm and the other at 34.9mm which I presume is (1 3/8 ) inch ordered a larger shaft for the engine as it was a closer match to the other shaft.. most of the modern day centrifugal clutches have small diameter centres.

 

[God mode restorations]

OK. After a good clean up and a measure one shaft is 38mm. And the other is 34.9mm.
1 3/8 .

 

[gavcarter]

used a lot in scooters, able to handle up to around 12HP ,might be worth looking into and making it fit....

 

[God mode restorations]

used a lot in scooters, able to handle up to around 12HP ,might be worth looking into and making it fit....

I looked at go cart . Scooters ect. But most of them are very small shaft diameter. A lot of plant like wacker plates use them but are small.