cemig170

[motormate]

Hi all
Does anyone have any information on the Cemig170 welder.
In particular the controller board especially the wire feed speed control section.
A circuit diagram would be very helpfull.
It has the same circuit board as pictured in the Brown 200 post.
Regards

 

[mike 109444]

Motormate Take a look at this link. Not directly related but mention of the 171 and where it comes from and who rebranded (like Brown?) them
http://www.mig-welding.co.uk/forum/showthread.php?t=28707&highlight=cemig

 

[motormate]

Electronics is not problem.
But this board is very complex and would take many hours to carry out
I will probably have to connect it to temporary power supply and take it from their.
Thanks anyway.

 

[mike 109444]

Another link.
http://weldingweb.com/showthread.php?t=52604
Do you have a pic of your pcb. Could be that someone might recognise it from another m/c

 

[motormate]

Pictures of the controller can be found on the Brown MIG200 thread.

Thanks for your info.