Cebora Pocket Turbo 130 Casing

  1. unmol New Member

    Messages:
    2
    Location:
    London
    Hi Guys. Im new to the forum, was just browsing and its great! Very help full guides and info on here. Ive been welding for a few years, mostly on project cars. At the moment I have a Cebora Turbo 130. Just wanted to know if any one or any suppliers can get hold of the casing for this welder (The two red cases on either side. Mine is quite battered. The welder it self is working great. I understand Snap-on make these too, so will any Snap-on casing fit or any other make?. New casing please.

    [​IMG]

    Thanks in advance.
     
  2. rikrobson

    rikrobson Member

    Messages:
    3,849
    Location:
    Perth, Scotland
    They are all quite old, Mines certainly been round the block a few times. I'd be surprised if you can actually get ant replacement sides. you could bet some 1mm sheet and make some.
     
  3. cumbriasteve

    cumbriasteve Moderator

    Messages:
    9,657
    Location:
    Cumbria UK
    Welcome to the forum:

    If they are only battered and you are into car work then treat them as a battered wing, a bit of panel beating, respray and a sticker off one of the 'design your own' lot off ebay and they will be like new.
     
    cliff366 likes this.
  4. Appyasme1

    Appyasme1 Member

    Messages:
    1,389
    Location:
    Lancashire
    Starparts could help.
     
  5. Wozzaaah

    Wozzaaah The wizard of woz Staff Member

    Messages:
    15,089
    Wiltshire, UK
    Highly unlikely. ;)
    I doubt you'll find anyone who sells a case for one of those.
     
  6. Appyasme1

    Appyasme1 Member

    Messages:
    1,389
    Location:
    Lancashire
    Just a stab in the dark Wozzaaah.:drunk:
     
Advertisements