Cebora car30 torch problem

[RedOrZed]

Just acquired a Cebora 30 plasma cutter at the local auction for £95 (well, more like 110 with the buyers premium).

Only problem is half the torch is missing Anyone know where to get spares.

Have tried to pm Weldequip but the mailbox is full!

 

[Wozzaaah]

Did you not see that we have a plasma cutter section?

I'm sure someone else has the same model and managed to find a torch that fitted, have a good search through this section.

 

[RedOrZed]

I did, but it was more of a "woo look what I got" post than anything else, plus a hope Weldequip would see it and empty his inbox

 

[Wozzaaah]

You did see we had a plasma section or you did have a search through it?
I've just found the very thread that you need, NotANormalCoder is the man to speak to.

 

[astro_al]

I have a spare trafimet plasma torch - what do you need?

Al.

 

[RedOrZed]

Thanks Wozzaah!

It's in the car al at the moment, will dig out inna bit and find out what model etc. Cheers!

 

[NotANormalCoder]

Check this for a parts breakdown for your torch http://www.woodfieldwelding.com/PocketPlasma.aspxI also have some handles complete with microswitch which are not shown on the web page.
Dave

 

[RedOrZed]

Well it's definately a CAR30m, missing the whole head assembly, I suspect the microswitch as well, as there are a lot of wires hanging out of the handle!

I don't have suffficient electrickery to run the compressor yet, so will have to do that & buy the parts in the meantime. Although it's looking like £150 worth of parts to get it going, might be better off to stick this one on here or evilbay and buy a newer one later on