Car roller/tilter

[Rich.C]

Lads and lasses, would any of you have pictures of a car roller/tilter that you have made?

I've seen some which fit onto the hubs and tilt the car, but I'm working on a bare shell with no axles on.

So any pics/drawings and sizes of steel used would be a big help.

Thanks a lot

 

[MrFluffy]

Try searching for "rotisserie", you get a lot more results back for that keyword.

 

[drjim]

Also check out the "lifting the car really high" thread.

 

[Smiffy]

Chassis rollers

Try C J Autos (cjautos.org.uk), they sell a chassis roller that bolts to the bumper mount brackets.
Good luck.

 

[greyshirtguy]

Have you taken a look at Malcolms?

 

[side-show-bob]

I made this for my bug

 

[Stuggi]

No offense, but I seriously wonder if your rig could take the full weight of the car. That bearing design looks a tad too flimsy

Though I have no idea what so ever on how one would go about to get a fully loaded bug up on a setup like that, bit hard to find places to attach the roller to

 

[side-show-bob]

To attach the full shell it is mounted to the front and rear bumper mounts.

 

[Stuggi]

Well, you're bumpermounts must be some HD stuff, cause mine are barely able to support the bumpers themselves

 

[Rich.C]

Thanks for all the help fellas, I found this one on the internet http://www.harwoodperformance.bizland.com/1941buick/Editorial_20.htm it has loads of photos, a materials list and drawing. It may help someone else out.

 

[spoiltbrat]

car tilter

i have plans purchased from ebay i can send i,m going to build one very soon using 2 engine hoists for the end of the frames i have a car tilter at the moment but if your removing axles it will be no use