Guys..
Yesterday.. I attempted to weld a repair section into my car.
I cut the repair section as close to the whole I was filing as possible then spot welded in in place.
The areas where the metal was touching I was able to weld fine.. but where there where gaps to fill, (1mm ish) I just kept blowing through.
What is the technique for doing this sort of welding?
Amit
Yesterday.. I attempted to weld a repair section into my car.
I cut the repair section as close to the whole I was filing as possible then spot welded in in place.
The areas where the metal was touching I was able to weld fine.. but where there where gaps to fill, (1mm ish) I just kept blowing through.
What is the technique for doing this sort of welding?
Amit