Butt weld pipe fittings

[quattro]

Where could I buy a small amount of such fittings without paying through the ass.

Looking for 45deg, 1 1/4", 10s.

 

[superls]

hi, funnily enought i have just signed in to ask almost the exact same question, but im after 90 deg ones, i know aalco do them but there expensive, still looking for somewhere cheaper.

 

[Welderpaul]

We pay around £6 for a 90 degree bend, thats 48.3 od, grade 304L. We use Q Railing.

 

[hotrodder]

First 3 hits with online prices from googling 'stainless weld elbows' UK pages only...

http://www.allstainlessltd.co.uk/categories.asp?category=9
http://www.colglo.co.uk/productlistallinone.php?category=2185237e0006
http://www.zx55.com/

Carriage will typically kill any savings over local sources with small quantities. Don't know about the other two but there's a £40 min order with Allstainless.

Can only speak for my local Aalco but doesn't usually take much to get a lower price- last time i needed 1 length of something for a job just asked if that was their best price and pointed out that i could get it cheaper elsewhere. Price immediatley dropped by a tenner or so

For a handful of bends/fittings i'd be phoning all the local stockholders first

 

[smithy1851]

you can try a few process pipe suppliers in brum..

neropipeline ltd are very good on price, not sure what the minimum delivery is, but we tend to go for next day service which is around £12.00,
they have a good selection of fitings on the shelf for despatch that day..

you can try fwb at wrexham but i find there expensive....

check out online 4 processs pipe fittings loads out there...

chris