K KennyA Member Messages 117 Jan 23, 2012 #1 Im making a small railing/fence for around a head stone and im using 20mm box section. im wondering whats easiest to put it into ground with. was going to form a spike on bottom to push it into ground. any one done something similar before? Thanks kenny
Im making a small railing/fence for around a head stone and im using 20mm box section. im wondering whats easiest to put it into ground with. was going to form a spike on bottom to push it into ground. any one done something similar before? Thanks kenny
G GeorgiePorgie pre-moderated Messages 957 Jan 23, 2012 #2 Make the railing,grind the box sections post with a sharp chamfered edge put it into position,give it a hammering into the soil...assuming it is soil?
Make the railing,grind the box sections post with a sharp chamfered edge put it into position,give it a hammering into the soil...assuming it is soil?
Hitch Moderator Staff member Messages 13,280 Location England Jan 23, 2012 #3 Just weld a bit of 10mm rod in the ends, just push in then....
K KennyA Member Messages 117 Jan 24, 2012 #4 Yeah its just for going into soil. i did think of round bar so think ill go with that as its easier and quicker. thanks
Yeah its just for going into soil. i did think of round bar so think ill go with that as its easier and quicker. thanks
G GeorgiePorgie pre-moderated Messages 957 Jan 24, 2012 #5 Round bars will be easier to pull out as opposed to square.
K KennyA Member Messages 117 Jan 24, 2012 #6 Went ahead with 10mm round bar and made them today thanks