pawsnizzy
Forum Supporter
- Messages
- 790
- Location
- Derbyshire, UK
Hi All,
Anyone using the above? I have one of these working perfectly on my Mill, so I thought I'd use the same on my Super 7 when I had to replace the motor. Can I get the remote controls to work? Can I hell! All wired the same as the mill, all configured the same, and it still won't have it.
I'm pretty certain that I've done something daft, but I can't see it - This is a bit embarrassing as I'm a qualified Sparky/Electronics/Measurement Engineer with over 40 years under my belt.
I'm after a remote Run/Stop, Fwd/Rev and speed control - I've done this kind of stuff countless times, and am left feeling a bit of a DH
Anyone using the above? I have one of these working perfectly on my Mill, so I thought I'd use the same on my Super 7 when I had to replace the motor. Can I get the remote controls to work? Can I hell! All wired the same as the mill, all configured the same, and it still won't have it.
I'm pretty certain that I've done something daft, but I can't see it - This is a bit embarrassing as I'm a qualified Sparky/Electronics/Measurement Engineer with over 40 years under my belt.
I'm after a remote Run/Stop, Fwd/Rev and speed control - I've done this kind of stuff countless times, and am left feeling a bit of a DH