Hi,
Im a newbie on here, I’m trying to weld VW T4 vehicle panels and the sliding door step. I have a Clark 130EN what settings would be best for this and technique? Help much appreciated. Thanks.
I'm unsure how experienced you are at MIG welding. I'd get some plain sheet steel and practise on that first, rather than steaming in and messing it up. Post some pics of your welds for sensible advice.
Personally I find 2 min is better on thin stuff rather than the very lowest setting just loads of spots rather than trying to run a seam, you get better penetration and the welds are a lot flatter. Having said that if your having to ask your not ready to work on a vehicle.