Spark plug
Member
- Messages
- 4,062
- Location
- Durham, England
ok, so I have a bit of round bar to machine, it's 300mm diameter x 100mm. I can get it in the lathe (just) if I drill and tap holes in it and bolt it to the face plate, Or I could do it in the mill.
The first task will be to face either side, bore a hole in the centre then skim up the out side. before it goes in the mill anyway to have a profile machined around the outside.
Sometimes it's too easy to overlook the easy option, how would you chaps tackle this?
The first task will be to face either side, bore a hole in the centre then skim up the out side. before it goes in the mill anyway to have a profile machined around the outside.
Sometimes it's too easy to overlook the easy option, how would you chaps tackle this?