Best start here

  1. Greisingel

    Greisingel New Member

    Messages:
    2
    Location:
    Kent, UK
    Newbie that is looking to get a small MIG welding box (Tooltronix 160A)


    Stunning piece of work on that 530i. Just wondering if, as a fellow Kent person, you could price up an offside rear jack point plate weld. I could cut out the rot and grind surfaces to leave an open rectangle. The vertical support has crushed as the edging over the wall was rusted concertinaed under load.

    The hole for the plastic foot could be re drilled. Just thought I'd ask as I don't know how to weld, though, I wouldn't mind learning.

    Looking either to try and do the job myself and could get very messy. Or trying to find a fellow Kentman to price up the job on a E39 540i with crushed offside rear jack point and reasonable rusting
     
    • image2.jpeg
    • image5.jpeg
  2. slim_boy_fat

    slim_boy_fat Forum Supporter

    Welcome aboard, fella. :waving:
     
  3. gaz1

    gaz1 Forum Supporter

    Messages:
    9,108
    Location:
    westyorkshire
  4. Greisingel

    Greisingel New Member

    Messages:
    2
    Location:
    Kent, UK
  5. gaz1

    gaz1 Forum Supporter

    Messages:
    9,108
    Location:
    westyorkshire
Advertisements