Omniata
Forum Supporter
- Messages
- 3,191
- Location
- UK
I want to roll some 10mm x 1mm copper bar or thicker into a scroll spiral to wrap round a ferrite rod for a reactor core...
Whats the best way to do this, should I heat it first??
It needs to scroll so the 1mm to 2mm edge is resting on the inside of the spiral and the wide edge is flat on, viewable from the end...
I'll try to get a picture if necessary...
Whats the best way to do this, should I heat it first??
It needs to scroll so the 1mm to 2mm edge is resting on the inside of the spiral and the wide edge is flat on, viewable from the end...
I'll try to get a picture if necessary...