How would you go about Bending aluminium flat bar without fracturing/ I made a prototype with 1/8 x 1 inch 4 bends into a rectangle and it bent ok with very minor fractures on the outside.
I then tried 3/16 x 1 inch and I tried bending one without heat and all corners fractured and one even snapped.
Then I tried heating it and it made little of no difference...
OH BTW I was using a proper bender from Metal craft.
I then tried 3/16 x 1 inch and I tried bending one without heat and all corners fractured and one even snapped.
Then I tried heating it and it made little of no difference...
OH BTW I was using a proper bender from Metal craft.