W.olly
Member
- Messages
- 3,564
- Location
- Radcliffe, Manchester
Will be making myself a lathe cabinet soon and as a bit hard on funds for a new cylinder for the mig I thought do stick, got myself 4mm plate mild steel. 115amp 3.2 rods, not the best rods from Machine Mart but do the job.
I couldn't decide if to do a full open corner or fully closed.
These are open and I am happy with them to say its been a good while since I done stick again.
Took a few attempts to get a tidy weld as j think it was me loosing sight of the weld and lifting to high.
These are particular order. But the better ones are my last.
flat one with a singlw run through
this onew strated well but then god knows what happend
another singe run through
then started to weave it a bit
I also did a weave to fill out the joint more the ones that are flat weld are just a run through.
Time to crack on you think ? or do you think I should do the inner corner aawell. ?
I couldn't decide if to do a full open corner or fully closed.
These are open and I am happy with them to say its been a good while since I done stick again.
Took a few attempts to get a tidy weld as j think it was me loosing sight of the weld and lifting to high.
These are particular order. But the better ones are my last.
flat one with a singlw run through
this onew strated well but then god knows what happend
another singe run through
then started to weave it a bit
I also did a weave to fill out the joint more the ones that are flat weld are just a run through.
Time to crack on you think ? or do you think I should do the inner corner aawell. ?