dan.taylor.1
General Tinkererer
- Messages
- 2,690
- Location
- Kendal, Cumbria
Hi folks,
Just fiddling getting my 100mm backplate er40 chuck mounted to my massive L2 spindle nose, I've a 7" diameter backplate, which with a 0.01mm indicator is showing 0.02mm on the face (went down to maybe 0.015mm after a stoning as there's some odd marks I may face off yet) and 0.03mm on the od of the rim.
That's about a thou I think. Is that acceptable for a collet chuck? I mean it's a amazon special so I'm not sure how concentric it is to be honest..!
Any help much appreciated.
Cheers, Dan
Just fiddling getting my 100mm backplate er40 chuck mounted to my massive L2 spindle nose, I've a 7" diameter backplate, which with a 0.01mm indicator is showing 0.02mm on the face (went down to maybe 0.015mm after a stoning as there's some odd marks I may face off yet) and 0.03mm on the od of the rim.
That's about a thou I think. Is that acceptable for a collet chuck? I mean it's a amazon special so I'm not sure how concentric it is to be honest..!
Any help much appreciated.
Cheers, Dan