norlander
Member
- Messages
- 3,389
- Location
- Europe, mocycling paradise
I was in the Welding suppliers the other day, trying to get a set for backpurging, they had nothing but, there were some fittings for inert gases, that might have been cobbled together to make a set up.
Anyway, he said folks round here use this-and showed me a roll of tape type stuff.
No good for for me as I would not be able to remove the tape easily after welding an exhaust.
Must admit I did not fully understand what he was saying, so I just had a google, and lo-here it is
http://www.aquasolwelding.com/fiback its too hi tech for me and not necessary for what I do, but I wondered if anyone on here actually uses it in their work?
Anyway, he said folks round here use this-and showed me a roll of tape type stuff.
No good for for me as I would not be able to remove the tape easily after welding an exhaust.
Must admit I did not fully understand what he was saying, so I just had a google, and lo-here it is
http://www.aquasolwelding.com/fiback its too hi tech for me and not necessary for what I do, but I wondered if anyone on here actually uses it in their work?
