Bryan Williams
Member
- Messages
- 1,232
- Location
- Manchester England
Want to change the rear pads, there is a motor on the calipers housing for the handbrake.
There's a couple of guides on YouTube on how to wind back the motor so as to take the pressure off the pads and ease removal.
Either unbolt the motor cover and wind the motor manually by sticking an electric drill in the drive , or connect the motor to the battery and wiz it back that way.
Looks easy enough either way, but when winding it back will it stop itself, or will I over wind, damage /burn out the motor if I'm not sharpish spotting when it's fully wound back?
Cheers.
There's a couple of guides on YouTube on how to wind back the motor so as to take the pressure off the pads and ease removal.
Either unbolt the motor cover and wind the motor manually by sticking an electric drill in the drive , or connect the motor to the battery and wiz it back that way.
Looks easy enough either way, but when winding it back will it stop itself, or will I over wind, damage /burn out the motor if I'm not sharpish spotting when it's fully wound back?
Cheers.