Richard Stowe
Member
- Messages
- 259
- Location
- Potter Heigham
Hi all I need to do some 3mm steel but i've run out of co/argon mix could i get away with using 100% argon. It's not load bearing!
not sure what to say to that everybody need advice some times!You‘d asked for advice, so regardless of folk saying you might get away with it, the correct answer is, no
I’ve had the same.I use quite a few different customer migs and one day at this particular customer workshop all the welds I did just sat on top and not one held, I wondered wtf?? It dawned on me that the gas bottle had been changed very recently and the bloody berks got pure argon by mistake and it didn’t get noticed.
Hi all I need to do some 3mm steel but i've run out of co/argon mix could i get away with using 100% argon. It's not load bearing!
It's all I use.you could get away with c02
Cheap as chips as wellstick .... always handy to have a set laying about for such occasions.