anyone tried one of these or has one ?

[Hood]

If you have another knackered grinder you can strip the head off with the armature then cut the armature shaft making sure it is long enough to fit in a drill chuck. Make up a small adapter and fit a drill chuck to the angle head, you now have an angle attachment for your drill

 

[T0rnado69]

Nice job. Is that a box from a couple sets of impact sockets

the snap on box ?

its the box the die grinder and carbide burr kit came in

 

[T0rnado69]

only had the one knackered grinder, lucky i still had that.
as i forgot all about it sitting in the cupboard, where it was put when the brushes went.
it was only when mentioned about using a knackered grinder for the shaft. i remembered about it.