MattH
Member
- Messages
- 4,521
- Location
- Cornwall
Started knocking up a cart to hold my Rtech Tig welder and cooler today.
Using offcuts from my extraction table project and a few other bits that have been kicking around.
Cut one of the bits of sheet for the bottom shelf before I called it quits today.
Tomorrow I need to cut the other two bits of sheet and then start on the rear axle and front castor mount plate.
Using offcuts from my extraction table project and a few other bits that have been kicking around.
Cut one of the bits of sheet for the bottom shelf before I called it quits today.
Tomorrow I need to cut the other two bits of sheet and then start on the rear axle and front castor mount plate.