The Buddah
I'm using phone for internet.
- Messages
- 307
Hello,
During a closer look at the body on my disco sill project i notices the rear body panel is flapping or not fixed rigid to anything and has a tare.
I'd like to repair this before the sills are fitted.
Could this be welded together using my portamig 185 ?
I do have some 1.5 and 2mm ali to practice with though it's thicker than car body. (i do have ali welding wire)
What about if i weld on the lowest setting and see if i can get half penetration on the 2mm piece would this this then be ok to repair the car body?
Cheers.
Mike.
During a closer look at the body on my disco sill project i notices the rear body panel is flapping or not fixed rigid to anything and has a tare.
I'd like to repair this before the sills are fitted.
Could this be welded together using my portamig 185 ?
I do have some 1.5 and 2mm ali to practice with though it's thicker than car body. (i do have ali welding wire)
What about if i weld on the lowest setting and see if i can get half penetration on the 2mm piece would this this then be ok to repair the car body?
Cheers.
Mike.