Michael G7x
Member
- Messages
- 34
- Location
- Aldershot, United Kingdom
Hi everyone,
I apologise for the high likelihood that this is a "how long is a piece of string" question, but I have recently bought a second-hand SIP Plasma 46 cutter (which is currently in the hands of some very slow couriers). I was wondering whether there was a minimum bore requirement for the air line, which I've yet to buy. I've got a Makita AC1350 compressor which I hope will provide sufficient puff.
Do you have any thoughts on the type, size or brand of air line which I should be looking at acquiring? My thoughts were that a 10mm bore would be fine, but was not confident about buying 8mm.
Thanks very much
Mike
I apologise for the high likelihood that this is a "how long is a piece of string" question, but I have recently bought a second-hand SIP Plasma 46 cutter (which is currently in the hands of some very slow couriers). I was wondering whether there was a minimum bore requirement for the air line, which I've yet to buy. I've got a Makita AC1350 compressor which I hope will provide sufficient puff.
Do you have any thoughts on the type, size or brand of air line which I should be looking at acquiring? My thoughts were that a 10mm bore would be fine, but was not confident about buying 8mm.
Thanks very much
Mike