3D printed part design.

[ukracer]

Any of you spent xmas learning fusion 360 and want to test your skills.

I need to print a few clips out but cant find them on thingiverse.

They are very small and i dont think they need to be ultra accurate. So if anyone could assist i can supply dimensions.

I would try myself but i still cant see the screen without getting headaches since i was assaulted.

 

[tflnemesis]

I will give it a go, looks fairly simple to mock up in fusion.

 

[ukracer]

I will give it a go, looks fairly simple to mock up in fusion.

Cheers mate. I will get the dimensions later tommorow

 

[JohnRUFC]

Pop up the dimensions and I will make it and post it on Thingiverse if you like?

 

[ukracer]

Sorry for delay i lost the part..lol

 

[tflnemesis]

Here you go mate:

https://www.thingiverse.com/thing:3414313

Had to guesstimate on height of bottom hole but it looks ok to me .

 

[ukracer]

Here you go mate:

https://www.thingiverse.com/thing:3414313

Had to guesstimate on height of bottom hole but it looks ok to me .

Awesome will print some off in the morning.

Looks brilliant...thanks again.

 

[ukracer]

I am not being ungrateful not printing it to test but my octoprint has gone wrong.

Its been a while since I printed anything at all but while I can see octoprint and it says its booting when I reaches the end it cant be accessed.

Internal Server Error
The server encountered an internal error and was unable to complete your request. Either the server is overloaded or there is an error in the application.

Looks like something went wrong during startup, the server is gone again. You should check octoprint.log.

I cant even read the logfile to see whats going on. Followed these steps but they dont help. https://discourse.octoprint.org/t/octoprint-crashed-cant-access-log-file/1425/4
so I will spend more time on solving my problem tonight hopefully.

 

[JohnRUFC]

Are you using PLA?

 

[ukracer]

Are you using PLA?

I will be if i can ever get octoprint running...lol

I was having a bad weekend and thinking "why me" and then i read about Wendle passing away.....and felt guilty.

 

[JohnRUFC]

What are you using them for?

 

[ukracer]

What are you using them for?

Just holding plastic covers in place....

 

[ukracer]

All printed now. Little bit tight but look like they will certainly do the job. Photos to follow later.