rikrobson
Member
- Messages
- 3,963
- Location
- Perth, Scotland
I've got one on my Boxford lathe.
there are several ways to control. I'm currently using the integral panel, but i'll be making a new panel, with speed contol.
They are setup to run at 400Hz so you need to reconfigure for it to run at 50Hz, its a couple of parameters.
Then you get full speed control and a jog function into the bargain.
You will need to have the motor in Delta
there are several ways to control. I'm currently using the integral panel, but i'll be making a new panel, with speed contol.
They are setup to run at 400Hz so you need to reconfigure for it to run at 50Hz, its a couple of parameters.
Then you get full speed control and a jog function into the bargain.
You will need to have the motor in Delta