Weldinator
Astalavista baby....
- Messages
- 770
On a recent painting job i think i had the clear coat too thin and have ended up with a run. I have researched a bit and found using a Stanley blade to scrape it flat, then wet sand with appropriate sand paper then polish up.
Is it possible to spray some solvent to check its nice and flat ?
Is it also possible after scraping it flat to just spray another coat on it even tough its cured for a quicker/easier solution ?
I'd love to be able to use 2k clear as its far easier to spray and get a nice flat finish, one day i might be able to use 2k clear.
Is it possible to spray some solvent to check its nice and flat ?
Is it also possible after scraping it flat to just spray another coat on it even tough its cured for a quicker/easier solution ?
I'd love to be able to use 2k clear as its far easier to spray and get a nice flat finish, one day i might be able to use 2k clear.