sawdustcaeser
novice welder!
- Messages
- 17
i am going to start the repair of my first project today. i bought the car 2 years ago, spent some time playing in it then it failed its M.O.T on the usual rot areas. i have an angle grinder and a Clarke 135 gas welder.
i am not sure how to get in to cut out the more fiddly holes in the section where the floor pan meets the inner sill. There is an awkwardly shaped grooved area. the floorpan seems to have rotted underneath where the electrical cable runs into the boot.
http://i153.photobucket.com/albums/s229/sawdustcaeser/rover resto/PICT0157.jpg
http://i153.photobucket.com/albums/s229/sawdustcaeser/rover resto/PICT0158.jpg
i am not sure how to get in to cut out the more fiddly holes in the section where the floor pan meets the inner sill. There is an awkwardly shaped grooved area. the floorpan seems to have rotted underneath where the electrical cable runs into the boot.
http://i153.photobucket.com/albums/s229/sawdustcaeser/rover resto/PICT0157.jpg
http://i153.photobucket.com/albums/s229/sawdustcaeser/rover resto/PICT0158.jpg