Martin870
Member
- Messages
- 89
- Location
- Lancashire England
I've just bought a 3000x1500x12mm plate for a shop bench I'm about to make but noticed the plate has a bow in it to explain where the bow is its left to right on the longest side so the bow is in the middle
The plate is still on my trailer at the mo I've not built the bench yet, currently got a lot on but when I put the top on the bench would ratchet straps around d the top of the plate and the bottom of the bench and a few welds in the center (welding the plate to the bench) be enough to get the bow out do you think?
I would like the plate as flat as possible
I do not have oxy acetylene
Thanks
The plate is still on my trailer at the mo I've not built the bench yet, currently got a lot on but when I put the top on the bench would ratchet straps around d the top of the plate and the bottom of the bench and a few welds in the center (welding the plate to the bench) be enough to get the bow out do you think?
I would like the plate as flat as possible
I do not have oxy acetylene
Thanks