Pilots need heroes too
New Member
- Messages
- 18
- Location
- Somerset
Hi everyone.
I recently bought a parweld 255i for welding both steel and ally. When cycling through the wire diameter settings as it's semi synergic, it only goes to 1.0mm or manual mode when you program it for aluminum. It's range is preset from 0.6 1.6mm.
Any ideas why it won't let me select the other settings as I have 1.2mm wire
Paul
I recently bought a parweld 255i for welding both steel and ally. When cycling through the wire diameter settings as it's semi synergic, it only goes to 1.0mm or manual mode when you program it for aluminum. It's range is preset from 0.6 1.6mm.
Any ideas why it won't let me select the other settings as I have 1.2mm wire
Paul