Thanks Frank, so would adding a little cellulose thinners work or is that not compatible? I'll give it a go today and see how it goes. I'll have to check my nozzle size but for some reason 0.4mm sounds familiar. I might have made that up though I have a big 3 phase compressor so that should do...
I've no experience whatsoever in spraying but I've a tin of Leyland trade red oxide primer. My question is will this paint be suitable for spraying? I have a gun and compressor that will do the job but would like to know what thinners will be suitable and how much to add?! How thin do I need to...
Cheers lads,
What sort of costs are you looking at for first setting up and for the annual renewal as a ball park figure? I can imagine its a lot of paper work and a bit of a ball ache at first.
I'm trying to decide which route I want to go down at the moment and wondering if forking out the...
Hi,
I have setup my own fabrication business and was looking at potentially doing some structural work in the future.
Could anyone me in the right direction of what is required as in codings, standards and WPS if needed?
Im assuming my company will have to be certified to BS EN1090 or if I...
I will say when I'm welding on 5 setting in short circuit it's about right for 3mm steel and if I move it up to 7 setting it's in and out of spray but blows a hole through so it's not far off. Will the gas make that much difference?
Hi,
I am looking at some welding gas advice, I currently have Cougar 20 which is 20% Co2 and 2% oxygen. I have been using this for a fair few years now and has been working fine. I have decided though due to now welding thinner pipe of 3mm mostly to get Cougar 5 when this bottle runs out which...