Thanks for the reply Already checked out Ebay. The keyed ones on Ebay are 10mm centre bore, 30mm od and 10mm wide where my is a keyed drive approx 8.2mm centre bore, 25mm od and 7.45mm wide
Sealey 170/1 Votage control switch
Hi Mike I get to weld another day ( Fried ). The brown stuff which is on top of the welder which I have always know as componsite ( though there is more than likely a proper name for it ) is the stuff I am go use for the euro connector insulation. Pondy has...
Hi there
I am hoping that someone here can help me with the wiring as I am converting my 170 to euro torch. There is no separate gas valve at the moment as the old one was in the handle. I will get a gas valve when I know what voltage to get and how to wire it and the feed motor up.
Sealey 170/1 Votage control switch
Hi Mike
Many thanks for all your help so far. Not had a lot of time lately. I have been trying to sort my torch that was falling to bits with out success. Have bought another srcap welder with a euro torch which I am now going to fit to the machine. I now...
Hi Mike
Found that the wires to and from the speed control board are mard as to where they should go so I wired the welder completely. Then I checked the AC and DC outputs on the rectifer with the torch trigger held on and got the following results. on the AC side switch position 1-21v...
Hi Mike
Checked the thermal cutout switch and I get a reading of 00.00 ohms. With the wiring connected up as the Sealey diagram I only get very low AC voltage readings of just 4 volts or less. I took wire off of diagram terminal F2 and connected it to switch terminal L2 and got the following...
Hi Mike
How do I check the output of the transformer with meter, from and where to please. The feed motor, speed control and little unit at the front of the top transformer wiring also need sorting out.
Cheer Paul
Sealey 170/1 control switch
Hi Mike
Sorry about the delay in answering but I had to go away unexpectedly. Borrowed a better meter so have got some new readings. I marked the double cables one Blue, one Red and one Green. The single cables one Yellow and one Black. The results of testing...
Hi Mike
I do not know the reason the wires taken off as I got the welder from a friend who got it from someone else. My meter only goes down to 200 I tried getting reading and the only readings I got were between first pair 1.1, second pair 0.6, third pair nothing. The switch chart with the...
Sealey 170/1 Votage control switch
Hi Mike
This is the results I got
Pos 1 L1 connects to 1 L2 connects to 5
Pos 2 L1 connects to 2 L2 connects to 5
Pos 3 L1 connects to 1 L2 connects to 4
Pos 4 L1 connects to 2 L2 connects to 4
Pos 5 L1...