dobbslc
Member
- Messages
- 11,085
- Location
- Hertfordshire UK
I need a few pointers on what's actually my first proper milling job!
I want to machine off the "nissin" name on these calipers so it and the face just under it are one flat surface.
I've tried using this type of what I think is called an end mill
but it's not wide enough to do the job in one pass and is leaving marks.
Do I need a fly cutter and if so what to buy?
Thanks for any advice and yes it is a 3 in 1 mill drill machine.....
I want to machine off the "nissin" name on these calipers so it and the face just under it are one flat surface.
I've tried using this type of what I think is called an end mill
but it's not wide enough to do the job in one pass and is leaving marks.
Do I need a fly cutter and if so what to buy?
Thanks for any advice and yes it is a 3 in 1 mill drill machine.....