- Thread starter Gizmo.Y
- Start date
the snooper
getting older by the day
- Messages
- 21,078
- Location
- Hull UK
any welding supplier should stock it
- Messages
- 14,665
- Location
- UK
Just look for a roll/length of 4mm/6mm ID hose - there's thousands on ebay. It's not specific to welding.
We use the braided hose type. Very strong.
We use the braided hose type. Very strong.
Richard.
Member
- Messages
- 18,344
- Location
- Cambridgeshire
the snooper
getting older by the day
- Messages
- 21,078
- Location
- Hull UK
I guess you mean crimped fittings, if so just cut the crimps and fit new ones
Mick B
Member
- Messages
- 216
- Location
- Orange. NSW. Australia
I replaced the original hard plastic hose with a piece of 6mm ID fuel line I picked up at the local car parts shop. The old line didn't have any clamps on it at all and because it was made from hard plastic I had to warm it up to fit it and cut it off with a knife to remove it. Now I have a couple of cheap screw up hose clamps on it.
the snooper
getting older by the day
- Messages
- 21,078
- Location
- Hull UK
merry Christmas mick, as its 9ish am 25th where you are
Mick B
Member
- Messages
- 216
- Location
- Orange. NSW. Australia
Thanks mate, yes it's now 9.20 am on THE day.
If I get what I asked Santa for (a new bench drill press) I will have to wait a week or so before I can even put it together, because I had an ingroinal hernia repaired the day before yesterday and I'm still quite tender .............. especially around my crown jewels which are now starting to turn black from the bruising. So no lifting for me.
If I get what I asked Santa for (a new bench drill press) I will have to wait a week or so before I can even put it together, because I had an ingroinal hernia repaired the day before yesterday and I'm still quite tender .............. especially around my crown jewels which are now starting to turn black from the bruising. So no lifting for me.
the snooper
getting older by the day
- Messages
- 21,078
- Location
- Hull UK
nasty, I don't envy you one bit
slim_boy_fat
Member
- Messages
- 29,532
- Location
- Scottish Highlands
You'll be glad that's fixed! 
Enjoy the [enforced] rest -hope Santa delivered the goods.
Enjoy the [enforced] rest -hope Santa delivered the goods.
Mick B
Member
- Messages
- 216
- Location
- Orange. NSW. Australia
I certainly am glad, and yes, santa did come good so now I have a big box with 45 kgs of drill press parts waiting to get put together and my lifting limit is 10 kgs ! I'll just have to sit down beside it and make drilling noises for now. (Drill drill drill, whirrrr whirrr ............ not sure how to make drilling sounds !)
