normspanners
Member
- Messages
- 8,853
I cannot believe they have produced a drawing like that, the number of people that must have followed the drawing and wondered why the vehicle was shaking to bits after, must be incredible.
Last edited:
- Thread starter marfyboy
- Start date
normspanners
Member
- Messages
- 8,853
But looking at the drawings they may not have been correct to begin with, just build them correctly with the yolks aligning
the only prop that I know of that runs out of phase is a disco front one and they have done that to take into account the different axle to g/b alignment, never really understood their logic should have had a double carden on there imho.
I'm totally lost with a couple of posts about the configuration of the props, the photo of the props are the same as fitted! can someone explain please or am I just being thick
normspanners
Member
- Messages
- 8,853
Drawings are not photos, the drawings are wrong they show the timing 90 deg out, you must not align them that way,
the photos look to be aligned correctly but it is difficult to actually see.
As said earlier the yolks have to be aligned with one another, to explain prop angles excetera is quite a complex subject.
https://www.google.co.uk/url?sa=t&r...7agMgG&usg=AFQjCNFijHmQoAT7KzuxRZQvhFn9E8rz8A
some light reading on the subject
the photos look to be aligned correctly but it is difficult to actually see.
As said earlier the yolks have to be aligned with one another, to explain prop angles excetera is quite a complex subject.
https://www.google.co.uk/url?sa=t&r...7agMgG&usg=AFQjCNFijHmQoAT7KzuxRZQvhFn9E8rz8A
some light reading on the subject
