Hydraulic ram question

[normspanners]

Here ya go had it in my WL
http://www.ebay.co.uk/itm/281158030023?ssPageName=STRK:MEWAX:IT&_trksid=p3984.m1423.l2649

 

[SBK]

Just bought one of these.

http://www.ebay.co.uk/itm/8-TON-AIR...108?pt=LH_DefaultDomain_3&hash=item3385f3987c

 

[Shox Dr]

Yes was thinking about that after looking through the plans again.
May just bite the bullet and buy one.

There's a guy on ebay selling rams of a good stroke for around 80quid. (or at least was when I last looked some 4-5months ago)

 

[SBK]

There's a guy on ebay selling rams of a good stroke for around 80quid. (or at least was when I last looked some 4-5months ago)

The one I just bought fits the spec I need just right.
will need to modify the Ram hole as its only 16mm seems a bit puney.

Did you make one from takas cycles ?

 

[Shox Dr]

The one I just bought fits the spec I need just right.
will need to modify the Ram hole as its only 16mm seems a bit puney.

Did you make one from takas cycles ?

Yes 14USD for the plans. I bought them as I wasn't willing to take the word of someone on the interweb, that plans they had were good, despite never building a bender from said plans.

I only used the dimensions, as I wanted to build one I could strip down and store when not in use. So it looks like a factory unit.

A few pics in this thread

 

[SBK]

Yes 14USD for the plans. I bought them as I wasn't willing to take the word of someone on the interweb, that plans they had were good, despite never building a bender from said plans.

I only used the dimensions, as I wanted to build one I could strip down and store when not in use. So it looks like a factory unit.

A few pics in this thread

Very nice build .

I am going to make the one on wheels looks pretty straightforward.
I will post some pics when its done.