Danez
Member
- Messages
- 468
- Location
- Lancashire, England
On the back of my rohr mig 200MI is this thread for the gas inlet. It did have a barbed fitting that screwed on which i have since lost!
I wanted to use a proper fitting anyway, I’ve got a 3/8 BSP hose (female both ends) coming from my regulator. I assumed that the thread on the welder gas inlet to be 1/4 BSP. So i got a 3/8 to 1/4 adaptor and it’s too large small for 1/4 BSP but deffo too big for 1/8 BSP.
So I’m at a loss on what to do, how to get gas in! the diameter is roughly 11.7mm. Could this be a NPT fitting?
I’d ideally like to get a adaptor so my 3/8 hose can fit on.
iirc this machine is basically a blackline 200?
cheers
I wanted to use a proper fitting anyway, I’ve got a 3/8 BSP hose (female both ends) coming from my regulator. I assumed that the thread on the welder gas inlet to be 1/4 BSP. So i got a 3/8 to 1/4 adaptor and it’s too large small for 1/4 BSP but deffo too big for 1/8 BSP.
So I’m at a loss on what to do, how to get gas in! the diameter is roughly 11.7mm. Could this be a NPT fitting?
I’d ideally like to get a adaptor so my 3/8 hose can fit on.
iirc this machine is basically a blackline 200?
cheers