AVI_8
Forum Supporter
- Messages
- 1,272
- Location
- Prestwick
Guys can I get some advice, finally going to get this welder connected up.
The connection at the back of the welder looks like a standard euro coupling so I’ll need one of those with a 6mm barb.
The connector going from the regulator to the flow meter looks to be 3/8 BSP but the female part of that fitting on the regulator looks more conical to the flow meters connection which looks more cylindrical is there something else I need to fit in between to create a good seal.
Also at the other side of the regulator is another smaller attachment point which has a hole in it, does this have to be blocked off?
The connection at the back of the welder looks like a standard euro coupling so I’ll need one of those with a 6mm barb.
The connector going from the regulator to the flow meter looks to be 3/8 BSP but the female part of that fitting on the regulator looks more conical to the flow meters connection which looks more cylindrical is there something else I need to fit in between to create a good seal.
Also at the other side of the regulator is another smaller attachment point which has a hole in it, does this have to be blocked off?