Collet identification

[Anguz]

Any guesses as to what sort these are?
The one with the ground diameter section is 24mm diameter
Wrote down all the dimensions but left them in the shed

 

[Pete.]

AI Hembrug B24 by the looks of it.

If you tell me you have a 13mm or a 16mm I'll send the boys round coz I just had to buy those two from the Netherlands

 

[roofman]

Looks like a Clarkson autolock collet

 

[Pete.]

Looks like a Clarkson autolock collet

Are those not LH thread?

 

[roofman]

Are those not LH thread?

From what i remember using mine i think just a normal RH Mate...Very rarely use my head as just use the set of R8,s i have straight up the snout

 

[Maker]

Looks like a Clarkson autolock collet

Not like any Autolock collet I've ever seen.

 

[roofman]

Hope i am not going mad here with confusion

 

[Mr Fro]

What's the diameter & length of the top one and what size is it?

 

[Anguz]

will do a quick sketch tomorrow, but off top of my head, mostly 1" ish diameter, and about 4" long

 

[Pete.]

Might be a 4c collet also the size looks about right.

 

[Anguz]

Might be a 4c collet also the size looks about right.

looks close... will check tomorow.....

 

[Hopefuldave]

Check the front ends, Crawfords had type numbers on, pair of crossed/back-to-back-overlapping C's as company logo

Dave H. (the other one)

 

[eLuSiVeMiTe]

Look similar to the Crawford collets in my smart and browns. Also similar to hardinge just to throw another option in the mix.

 

[Pete.]

Hope i am not going mad here with confusion

I think the only confusion is that you (and I) might have meant Crawford Trugrip collets.

 

[roofman]

I think the only confusion is that you (and I) might have meant Crawford Trugrip collets.

Nope! i am going to embrace my madness with pride mate as i did think they where Clarkson looked at my Clarkson chuck today and hit myself on the hand with a nice old heavy file

 

[Anguz]

 

[eLuSiVeMiTe]

404 | Model Engineer & Workshop Magazine

It looks like we've lost a piece!404: Page not found This page could not be found. Maybe try a search? If it's a forum topic you are looking for, ...

www.model-engineer.co.uk

Not quite

 

[Anguz]

didnt realise/hadnt considered how many differing types till i went down this rabbit hole

 

[Pete.]

The 24mm shank collet is definitely a Hembrug B24, I just measured a brand new one I have here.

The 23mm is the same as the collets that (should have) came with my TOS mill except for being about 14mm shorter.