Robert1998
Forum Supporter
- Messages
- 225
- Location
- Spain
Hello. This question may seem very silly...
I have a small angular grinder (125mm disc). When I use it in my hands there is no problem, but when I use it in a support like this one
sometimes after a few seconds the amount of sparks decreases and stop cutting (The disc is turning at the same velocity).
I image is something with the geometry of the cut, but I don´t know how to solve it. I move the piece and is fixed, but this is very annoying.
Thank you.
kind regards
I have a small angular grinder (125mm disc). When I use it in my hands there is no problem, but when I use it in a support like this one
sometimes after a few seconds the amount of sparks decreases and stop cutting (The disc is turning at the same velocity).
I image is something with the geometry of the cut, but I don´t know how to solve it. I move the piece and is fixed, but this is very annoying.
Thank you.
kind regards