gaz1
Member
- Messages
- 18,175
- Location
- westyorkshire
yes you can a bit ackward to do it but since its plastic and old plastic gives in cold weather
you can wiggle them enough depending on the glue thats used to glue the plastic together
some will some wont just becareful not to damage that pcb board
hold close on the pcb board near the part and then grab the top see if it will wiggle or move get one side loose the other normaly gives a bit quicker
then clean the points ive done it before
you can wiggle them enough depending on the glue thats used to glue the plastic together
some will some wont just becareful not to damage that pcb board
hold close on the pcb board near the part and then grab the top see if it will wiggle or move get one side loose the other normaly gives a bit quicker
then clean the points ive done it before